Lenovo A540 All In One User Manual
Page 47
Note: It may be helpful to place the computer face-down on a soft flat surface for this procedure. Lenovo
recommends that you use a blanket, towel, or other soft cloth to protect the computer screen from scratches
or other damage.
To replace the LED panel:
Step 1.
Remove any media (disks, CDs, DVDs, or memory cards) from the drives, shut down the operating
system, and turn off the computer and all attached devices.
Step 2.
Unplug all power cords from electrical outlets.
Step 3.
Disconnect all cables attached to the computer. This includes power cords, input/output (I/O)
cables, and any other cables that are connected to the computer. Refer to “Left and right view”
and “Rear view” for help with locating the various connectors.
Step 4.
Remove the base cover. Refer to “Removing the base cover”.
Step 5.
Remove the hinge from the chassis. Refer to “Removing the hinge from the chassis”.
Step 6.
Remove the rear cover. Refer to “Removing the rear cover”.
Step 7.
Remove the camera. Refer to “Replacing the camera”.
Step 8.
Remove the LVDS cable and the camera-touch-backlight cables from the LED panel.
Step 9.
To install the new the LED panel:
a.
Connect the LVDS cable and the camera-touch-backlight cables to the connector on the
new LED panel.
b.
Reattach the camera to the LED panel.
Step 10. Reattach the rear cover to the LED panel.
Step 11. Reattach the hinge to the chassis, and reconnect the touch and LED panel cables to the
motherboard.
41