Lenovo ThinkServer RS140 User Manual
Page 40
1. Connect the mini-SAS connector of the mini-SAS to 3.5-inch SAS combo cable to the RAID card.
Note: For the RAID 500 Adapter, connect the mini-SAS connector to Port 0. For the RAID 700 Adapter,
connect the mini-SAS connector to Ports 3-0. See “RAID card” on page 21.
Figure 19. Connecting the mini-SAS connector to the RAID card
2. Connect the SAS-hard-disk-drive-LED cable to the hard-disk-drive-activity-LED connector on the
RAID card, if supported.
3. Install the RAID card to the riser card assembly. See “Installing the RAID card” on page 62.
4. Connect the other end of the SAS-hard-disk-drive-LED cable to the hard-disk-drive-LED connector on
the system board. See “System board components” on page 32.
5. Do the following to connect the hard disk drives:
a.
1
: Connect the SATA combo connector 0 of the mini-SAS to 3.5-inch SAS combo cable to the
hard disk drive 0.
b.
2
: Connect the power connector of the mini-SAS to 3.5-inch SAS combo cable to the 4-pin power
connector which is near the memory modules on the system board.
c.
3
: Connect the SATA combo connector 1 of the mini-SAS to 3.5-inch SAS combo cable to the
hard disk drive 1.
d.
4
: Connect the other power connector of the mini-SAS to 3.5-inch SAS combo cable to the other
available 4-pin power connector on the system board.
For more information, see “System board components” on page 32.
Figure 20. Connecting the mini-SAS to 3.5-inch SAS combo cable to the hard disk drives
28
ThinkServer RS140 User Guide and Hardware Maintenance Manual