Lenovo ThinkServer RS140 User Manual
Page 75
To install the RAID card, do the following:
1. Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all
power cords from electrical outlets and disconnect all cables that are connected to the server.
2. If the server is installed in a rack cabinet, remove the server from the rack cabinet and place it on a flat,
clean, and static-protective surface.
3. Remove the server cover. See “Removing the server cover” on page 55.
4. Locate the riser card assembly in the server. See “Server components” on page 17.
5. Remove the screw that secures the PCI-Express-card-slot bracket and then remove the bracket from the
chassis. Store it in case you later remove the PCI Express card and need the bracket to cover the place.
Figure 33. Removing a PCI-Express-card-slot bracket
6. Touch the static-protective package that contains the new RAID card to any unpainted surface on the
outside of the server. Then, take the new RAID card out of the package.
Note: Carefully handle the RAID card by its edges.
7. Connect the mini-SAS to SAS combo cable to the RAID card. See “Connecting the cables” on page 22.
.
Installing, removing, or replacing hardware
63