Lenovo IdeaCentre Q200 - Manual (Page 31)

28
Hardware Replacement Guide
16. Install the heat sink and fan assembly on the system board.
17. Connect the heat sink and fan assembly cable to the system board. Refer to
the “Identifying parts on the system board”.
18. Install the system board into the chassis and allign the screw holes with those
in the chassis.Insert and tighten the screws that secure the system board.
Refer to the “Replacing the system board”.
19. Reconnect the disconnected cables to the system board.
20. Refer to the “Completing the installation”.
Replacing the hard disk drive
Attention
Do not remove the computer cover or attempt any repair before reading the
“Important safety information” in the Safety and Warranty Guide that was
included with your computer or in the Hardware Maintenance Manual (HMM)
for the computer. To obtain copies of the Safety and Warranty Guide or
HMM
, go to the Support Web site at http://www.lenovo.com/support.
Important
When you receive a new hard disk drive, you will also receive a set of
Operating System Recovery CD. The set of Operating System Recovery
CD
will enable you to restore the Operating System of the hard disk. For
more information on recovering factory-installed software, refer to “OneKey
Recovery” in the User Guide.
To replace the hard disk drive:
1. Open the computer cover. Refer to “Opening the computer cover”.
Note: For this procedure, it helps to lay the computer on its side.
2. Pivot the drive bay assembly upward to gain access to the system board.
31032756_HaWaii-HRG_EN.indd 28 2008.1.8 3:31:39 PM