Lenovo IdeaCentre A600 - Manual (Page 25)

22
Hardware Replacement Guide
5. Align the two screw holes on the new CPU fan to the two mounting holes on
the system bay.
6. Insert and tighten the two screws to secure the CPU fan.
7. Connect the CPU fan cable to the system board.
8. Close the system bay. Refer to step 9 of the “Replacing the hard disk drive”
section.
9. Refer to “Completing the installation.”
Replacing the MXM fan
Attention:
Do not remove the computer cover or attempt any repair before reading the
“Important safety information” in the Safety and Warranty Guide that was
included with your computer or in the Hardware Maintenance Manual (HMM)
for the computer. To obtain copies of the Safety and Warranty Guide or
HMM
, go to the Support Web site at http://consumersupport.lenovo.com.
To replace the MXM fan
1. Remove the computer cover. Refer to “Removing the computer cover.”
2. Open the system bay. Refer to step 2 of the “Replacing the hard disk drive”
section.
3. Remove the two screws that secure the MXM fan to the system bay.
31036449_A6_HRG_EN.indd 22 2009.1.12 3:50:34 PM