Lenovo IdeaCentre A600 - Manual (Page 26)

23
Hardware Replacement Guide
4. Disconnect the MXM fan cable from the system board and pull the MXM fan
away from the system bay .
5. Align the two screw holes on the new MXM fan to the two mounting holes on
the system bay.
6. Insert and tighten the two screws to secure the MXM fan.
7. Connect the MXM fan cable to the system board.
8. Close the system bay. Refer to step 9 of the “Replacing the hard disk drive”
section.
9. Refer to “Completing the installation.”
Replacing the keyboard and mouse (Only some models
are equipped with wired keyboard and mouse).
Attention:
Do not remove the computer cover or attempt any repair before reading the
“Important safety information” in the Safety and Warranty Guide that was
included with your computer or in the Hardware Maintenance Manual (HMM)
for the computer. To obtain copies of the Safety and Warranty Guide or
HMM
, go to the Support Web site at http://consumersupport.lenovo.com.
31036449_A6_HRG_EN.indd 23 2009.1.12 3:50:36 PM