AT&T 1412 - Manual (Page 57)

PHONE
PROBLEM SOLUTION
If you lose a call after You we re pro b ably almost out of ra n ge .
changing channels: Move closer to the base before changing
channels. Before placing another call,
set the handset in the base for at least
15 seconds.
PROBLEM SOLUTION
If the phone does not • Make sure the ringers are on. (See “Set
ring when you receive Line 1 Ringer”and “Set Line 2 Ringer”in
a call: the FE ATURE SETUP section of this manu a l .
• Make sure the telephone line cord is
connected firmly to the base and the
telephone jack.
• Make sure the AC adapter is plugged
firmly into an electrical outlet not
controlled by a wall switch.
• You might be too far from the base;move
closer.
• You might have too many extension
phones on your telephone line to allow
all of them to ring. Try unplugging some
of them.
PROBLEM SOLUTION
If your telephone • If you have dial pulse (rotary) service,
misdials: you’ll need to set the dial method to
. Follow the instructions under
“Set Dial Mode”in the FEATURE SETUP
section of this manual.
• If you have touch tone service and you
hear clicks while you are dialing, you’ll
need to set the dial method to
.
Follow the instructions under “Set Dial
Mode”in the FEATURE SETUP section of
this manual.
5 4
1412 2002.12.7 9:21 AM Page 54