AT&T 1412 - Manual (Page 8)

If you have two separate jacks, use both long line cords.
Connect a line cord from the wall jack you wish to designate as
your Line 1 to the jack labeled
L1/L1+L2 on the back of the
base. Connect the other line cord from the remaining wall jack
to the jack labeled
L2 on the back of the base. Make sure the
plugs snap firmly into place.
3 Charge the handset battery.
Place the handset in the base. Charge the battery overnight the
first time. After the first charge,the battery typically charges in
eight hours.
4 Check for dial tone.
After the batteries are charged,pick up the handset,press
and listen for a dial tone. Then press
. If you don’t hear a
dial tone,see IN CASE OF DIFFICULTY starting on page 52.
5 Turn base ringers on or off.
Use the L1 RINGER and L2 RINGER switches on the right side
of the base to set the base ringer volume to OFF, LOW or HIGH
for each line.
5
Line 2
Modular
telephone
jack
Line 1
Modular
telephone
jack
Standard
electrical
outlet
Power
Cord
L1/L1+L2 Jack
L2 Jack
1412 2002.12.7 9:20 AM Page 5