Autodesk XW8400 - Manual (Page 34)

Connecting System Components 3
28
Connecting the Autodesk Control Surface
The Autodesk control surface consists of three panels. You can use any combination of them. If
you are using more than one panel, you must use the network switch included with your
shipment to cross-connect them.
Refer to the Autodesk Control Surface User Guide for information on how to use the control
surface with Lustre.
N OTE : The illustrations in the following procedure only show the central module, i.e. the colour
grading panel. This is the only panel that has a USB connection for the integrated tablet, and a
network port. The other two panels only have a network port, which you connect to the network
switch.
3. Connect a Slave Renderer to the Lustre
workstation (Windows only). “Connecting the Slave Renderer to a Lustre
Workstation”
on page 33.
4. Connect the workstation to video I/O
components. “Connecting Video I/O to a Master or HD Station”
on page 36.
5. Connect the workstation to a high-speed
data link device. “Connecting to a High-Speed Data Link Device
(HSDL)”
on page 39.
6. Connect the workstation to audio I/O
components. “Connecting Audio Hardware” on page 39.
Step: Refer to: