Konica Minolta bizhub PRESS C8000e - Manual (Page 47)

Chapter 1: Preparation for Use Paper Setting
1-25
1
2
3
4
5
7
9
8
10
6
Preparation for Use
16.
Measure the misalignment between + marks [1] to [4] on
[back] (the back side) and the same marks on [front] (the
front side) of the output chart.
• The gray + mark in the figure below represents the one on [front] (the
front side), and the black + mark on [back] (the back side).
• Using a scale, measure the horizontal and vertical misalignments in
each print position. You can measure and enter the value in 0.1 mm
increments.
17.
Press [X] or [Y] of the points from [1] to [4], and then enter
the measured value for each.
• Use [+/-] to specify the value to be positive or negative. If the + mark
on [back] (the back side) is misaligned rightward or downward,
select the plus sign. If it is misaligned leftward or upward, select the
minus sign.
18.
Press [Adjustment Start].
• The Both Sides Adjust screen will be restored.
19.
Press [Close].