Ameriphone Q90 - Manual (Page 15)

2. Press F1 to enter
Dial mode and
Enter Name or
Number or Select
Directory with
will be displayed.
3. Type in the name of the person
you are calling then press Return
to enter your selection.
Or:
4. Press or until the
desired name appears. Then press
Return to dial the directory
number.
5. When the dialing sequence ends
your Q90 will automatically display
call status messages such as
Silence!!!! , Ringing... , or
Busy Signal!!!! .
3. Last Number Redial
With the Q90 turned on,
press F2 to redial the
last dialed number.
The number will be
displayed below
Last Number Redial
on the screen.
4. Answering a Phone Call
1. When there is an
incoming call,
the built-in ring
flasher will flash.
F1 F3 F
! @ # £
1 2 3
DIAL QUICK#
F2 F2
REDIAL
CHAPTER 6
(CONTINUED)
Z X C
Shift Ctrl Ctrl
Hold down Ctrl
and press F1
to hang up and
try again.
7. If the line is not
busy, Silence!!!!
and Ringing....
will be displayed
alternately.
8. If the other party
answers by TTY,
the SIGNAL light
will brighten and
you’ll see a
greeting message on the screen.
9. If the party answers by voice, the
SIGNAL light will flicker.
If Auto ID is on, the Q90 will send
Baudot tones to tell the person you
are calling that this is a TTY call
(see Auto ID page 22).
10. After the conversation is over, hold
down Ctrl and press Power to
turn off the Q90 or hold down Ctrl
and press F1 to hang up and
make another call.
2. Dialing from the Phone Directory
To dial this way, you must first have
names and phone numbers stored in the
directory. See Chapter 5 to create a
phone directory.
1. Press the Power key to turn on
the Q90.
Œ
Œ
Œ
Œ
13