Ameriphone Q90 - Manual (Page 16)

B. Making a Phone Call
(Cellular Phone or
Cordless Phone)
3. Make sure Hi-Speed ™ is off by
pressing F7 once or twice, as
needed.
4. Hold down Ctrl and press F3 .
The display will show:
Cell Phone Standby Mode .
5. When a call comes in, the ring
flasher will flash. The display will
show :
Ringing... Answer Your Cell Phone!
6. Start typing.
7. When finished, hold down Ctrl
and press Power to turn off the
Q90 or hold down Ctrl and press
F3 to enter Standby mode again.
Notes:
1. Cell Phone Standby Mode turns
off if you receive a call or if you
touch a key. To reset it, repeat
step 4 (above).
2. Some cell phones and cordless
phones are designed so that the
Q90 Ring Signaler will not flash
when a call comes in. If your
phone is like this, skip steps 4
and 5 (above) and watch the dis-
play on your phone to tell if a call
is coming in.
CHAPTER 6
(CONTINUED)
2. Press any key to answer.
3. When you answer, the Q90
displays the message
On Line Ready!
You may now
begin typing a
greeting message
or just hold down
Ctrl and press
Q to send the
preset message,
HELLO GA .
14
Z X C
Shift Ctrl Ctrl
1 2 3
Q W E
A S
1. Dialing from a Cell Phone or
Cordless Phone
1. Press Power to
turn on the Q90.
2. Make sure
Hi-Speed ™ is off
by pressing F7
once or twice, as needed.
3. Dial the phone number using the
cell phone or cordless phone.
4. Start typing when answered.
Note: Hi-Speed™ cannot be
used during a cell phone call
.
2. Answering a Cell phone or
Cordless Phone
1. Turn on your cordless or cell
phone and connect it to the Q90.
2. Press Power to turn on your Q90.
F6 F8 F9
^ & *
6 7 8
SAVE HC MSG 2
F7
Hi-SPEED