Konica Minolta Printgroove - Manual (Page 105)

7 Workflow Administration
7-6 Printgroove POD Guide Quick Start Guide
2
Note
You can edit the two prepared transitions but you cannot delete them.
To create a Workflow:
1
On your Home page, click [Configuration] - [Workflow] - [Builder]. The
[Workflows] screen opens.
2
To create a new Workflow, click [New Workflow]. The [New Workflow]
screen opens].
This screen is divided into two sections: Top Section and Bottom Sec-
tion. Nodes are selected in the Top Section of the screen, by selecting
values in the [Select the FROM Node] (Step 1 on the GUI) and [Select
the TO Node] (Step 2 on the GUI) drop-downs. Transition Parameters
can be viewed and modified by clicking the Edit link (Step 3 on the
GUI). When you click the Update button (Step 4 on the GUI), the Node
and its Transition are added as the next step in the Workflow. The New
Node and its Transition appear in the Bottom Section. To modify the
Node and/or its Transition, select the Node in the Bottom Section. Its
values will appear in the Top Section. Click [Cancel] or [Apply], as re-
quired.