Konica Minolta Printgroove - Manual (Page 26)

Basic Information 2
Printgroove POD Guide Quick Start Guide 2-11
Node Triggers are preplanned events that occur when a job has been sitting
at a node for a specified period of time without a change in status.
You can use the Printgroove POD Guide without using the Workflow func-
tion, but this function enables you to automate all stages from job submis-
sion to fulfilment.
2.2.1 Predefined Workflow and Nodes
Two nodes are predefined. No workflow is predefined.
Default node names are “Printshop Node” and “Closed”. The “Printshop
Node” is used to open the workflow and “Closed” is to close the workflow.
These nodes cannot be deleted.
The “Printshop Node” can be edited except for the node name and node
type. “Closed” nodes cannot be edited.
You can create workflows and nodes according to the procedures described
in “Workflow Administration” on page 7-1.
2
Note
To create a workflow, create nodes to add to the default workflow.