Konica Minolta bizhub PRESS 2250P - Manual (Page 12)

Operator Manual STR0202 & SFM0704
DBCB-0512-0066-V005
STR0202 2-Side Trimmer & SFM0704 Square Fold Module
V005 RI01 23-04-2012 DBCB-0512-0066-V005 - 12 -
4. Operating the STR (continued)
4.3 Job Setup
Proceed the following steps to set up the Job:
1) Determine the length of the booklet before trimming (= D ‘Input Size’) in mm.
2) Determine the length of the booklet after trimming (= A ‘Finished Size’) in mm.
3) Subtract ‘A’ from ‘D’ and spread the difference (= ‘Total Waste’) over ‘B’ and ‘C’.
If necessary, adjust the Trim Size symmetrical or asymmetrical (See Chapter 4.9 Center
Offset ).
As a rule, the following formula has to be correct in order to get the desired result:
Finished Size (booklet after trimming) (A)
Waste (front trim) (B)
Waste (rear trim) (C) +
Equals: Input Size (booklet before trimming) (D)
or short: A + B + C = D
B 2- 35mm waste (top)
C
A
Bypass :
Min. 150mm
Max. 320mm
Trimmed size:
Min. 200mm
Max. 320mm
min. staple
distance 40mm
min. staple
distance 40mm
Finished
Size
(booklet
size)
2- 35mm waste (bottom)
D
D
D