Konica Minolta bizhub PRESS 2250P - Manual (Page 18)

Operator Manual STR0202 & SFM0704
DBCB-0512-0066-V005
STR0202 2-Side Trimmer & SFM0704 Square Fold Module
V005 RI01 23-04-2012 DBCB-0512-0066-V005 - 18 -
4. Operating the STR (continued)
4.9 Centre Offset
For trimming the bleed off the booklet a Center Offset can be set. This means that it is possible to
trim asymmetrical (trim more from the upper or lower side of the booklet)
A positive Center Offset will result in a booklet trimmed more on the upper
A side of the booklet.
negative Center Offset will result in a booklet trimmed more on the lower
(See example below: Input Size 297.0mm, Finished Size 260.0mm)
side of the booklet.
Fig. 1 Fig. 2
Step Action Remarks
1. Center Offset (if necessary) Use the ‘
▲ / ▼ ’ buttons to select ‘Side Trim’ and press
the ‘Enter’ button (Fig. 1).
2. Adjust ‘Center Offset’ Use the ‘
▲ / ▼ ’ buttons (Fig. 2) to select ‘Center Offset’
and use the ‘ + / -‘ buttons to adjust the ‘Center Offset’.
Press ‘Enter’ (Fig. 3) to confirm the settings.
3. Save settings. After the Center Offset is adjusted press ‘Jobs’ (Fig. 1)
and press ‘Enter’ (Fig. 2) to save the settings.
Centre Offset:
15mm
Centre Offset:
-15mm
Centre Offset:
0mm
33,5mm Waste
33,5mm Waste
3,5mm Waste 18,5mm Waste
3,5mm Waste
Finished Size:
260.0mm
Infeed Size:
297.0mm
18,5mm Waste