Konica Minolta bizhub 751 User Manual
Type the 8-digit Administrator Password registered in the machine in the "Administrator Password"
If the "Save the administrator password" check box is selected, the Administrator Password
entered is stored in the PC being used. If you do not want the Administrator Password stored,
clear the "Save the administrator password" check box.
If a wrong Administrator Password is entered, a message appears that tells that there is a
mismatch in the passwords. Enter the correct Administrator Password.
If the Enhanced Security mode is set to [ON], entry of a wrong password is counted as
unauthorized access. If a wrong Administrator Password is entered a predetermined number of
times (once to three times) or more set by the Administrator of the machine, a message
appears that tells that the machine accepts no more Administrator Passwords because of
unauthorized access for any subsequent entry of the Administrator Password. The machine is
then set into an access lock state. To cancel the access lock state, settings must be made by
the Service Engineer; or, turn off, and then turn on, the main power switch of the machine. If the
main power switch is turned off and on, the access lock state is canceled after the lapse of time
set for [Release Time Settings]. When the main power switch is turned off, then on again, wait
at least 10 seconds to turn it on after turning it off. If there is no wait period between turning the
main power switch off, then on again, the machine may not function properly. Here is the
sequence, through which the main power switch and sub power switch are turned on and off:
Turn off the sub power switch
Turn off the main power switch Turn on the main power
Turn on the sub power switch.
If the Administrator Password is forgotten, it must be set again by the Service Engineer.
Contact your Technical Representative.