Konica Minolta bizhub 364e - Manual (Page 37)

How to Use the Authentication Unit 3
AU-211P 36
3.4.2 Related Settings
This section explains how to configure the SMB TX settings on the MFP that
supports this system.
Client Settings
Configure the setting to perform SMB TX.
On the MFP control panel, tap [Utility] - [Administrator Settings] - [Network
Settings] - [SMB Settings] - [Client Settings].
Item Description
ON/OFF Select [ON].
SMB Authentication
Setting The SMB authentication type is set to [Kerberos].
Authentication Setting if
Kerberos Fails Select whether to perform NTLM authentication when
Kerberos authentication has failed.
User Authentication
(NTLM) Select whether or not the NTLM user authentication is
performed.
DFS Setting To perform SMB TX in a DFS (Distributed File System)
environment, select [Enable].
Setting when NTLM is
enabled Select which operation is to be performed when
authentication has failed using the Kerberos
authentication ticket.
• If [Yes] is selected while [Authentication Setting if
Kerberos Fails] is set to [Enable NTLM v1/v2], the
screen for entering the user ID and password
appears when authentication has failed using the
Kerberos authentication ticket. NTLM v1/v2
authentication can be performed by entering the
user ID and password.
• If [No] is selected, it results in an authentication
failure.