Konica Minolta bizhub PRO C6500P - Manual (Page 235)

Setting Parameters in the Job Parameters Window 227
Exceptions
1. In the Type list, select the pages in your job in which the media
type will be different.
2. Depending on the option you selected in the Type list, perform
one of the following steps:
a. For Page range , type the page range in the box.
b. For Front cover or Back cover , select the Duplex check box to
print the first two (or last two) pages of the job as the cover
page (back cover).
c. For Inserts , select Before or After and type the page number
that will precede or follow the insert. Then, in the Quantity
box, type the total number of inserts you want to add.
3. In the Tray list, select the tray in which the specified media type
is loaded.
4. Click Advanced Options .
5. In the Destination profile list, select a destination profile.
6. In the Trim orientation list, select the trim orientation for the job.
7. If you have a perfect binder finisher connected and you want a
Z-fold in your job, from the
Folding list, select Z-fold .
8. Select Apply .
Note: If the imposition type is saddle stitch, select Cover to print
both a front and back cover page on a different media type. Select
Middle sheet to print the internal sheets on a different media type.