Konica Minolta bizhub PRO 1050P - Manual (Page 31)

The maximum number of sheets/pages allowed for a booklet
with folding depends on the paper weight:
50-91 g/m² 50 sheets 200 pages
92-130 g/m² 20 sheets 80 pages
131-161 g/m² 15 sheets 60 pages
162-209 g/m² 10 sheets 40 pages
210-244 g/m² 5 sheets 20 pages
If the allowed number of sheets is exceeded, the booklet will
not be folded.
Note for Macintosh users: Do not use the Booklet option in the
Page Setup dialog, but only the one in the printer driver plug-
in.
• 2 in 1 – 2 document pages are arranged side by side on each
sheet. I.e. sheet 1 contains pages 1+2, sheet 2 (or the back
page of sheet 1) contains pages 3+4.
The sheet size is twice the document page size. Document
pages are printed in original size. The sheet size is twice the
document page size.
• 2 Repeat – 2 copies of a document page are arranged side by
side on each sheet. I.e. sheet 1 contains 2 copies of page 1,
sheet 2 (or the back page of sheet 1) contains 2 copies of page
2. The resulting paper pile can be center cut to obtain twice the
number of copies.
2 Repeat can be used, e.g. to print A5 documents on A4 paper
or Statement documents on Letter paper and double the
number of copies.
• 2 Repeat Reverse – Like 2 Repeat, 2 copies of a document
page are arranged side by side on each sheet such that the
resulting paper pile can be center cut to obtain twice the
number of copies. However, the second page is rotated by 180
°
such that the side to be cut is the same for both pages.
The arrangement of the pages is determined by the Binding
setting. The binding side (left, right for portrait pages, top,
bottom for landscape pages) indicates which side is designated
for binding (opposite the cut side).
2. Double Sided (duplex) – document pages are rendered for printing
on both sides of a sheet.
3. Binding – selects the processing side (left, right, top) for several
other options. See Layout, Duplex, Staple, Punch.
4. Staple – selects the staple mode:
• Off, 1 staple (left/right at the corner), 2 staples (at the side)
Binding side left or right determines also the staple position.
5. Punch – selects the punch mode:
• Off, 2 holes, 3 holes / 4 holes
The punch side (left, right, top) is determined by Binding.
The availability of 3 or 4 holes depends on the installed punch unit.
See “Installable Options” about how to configure the punch unit.
The staple and punch options are applied across the feeding
direction (to the edge of the paper which leaves the copier last).
Therefore they restrict the orientation of the paper in the tray. E.g.,
Konica Minolta bizhub PRO 1050 Printer Driver Windows Printing
• 31