Konica Minolta bizhub 421 - Manual (Page 44)

501/421/361 2-17
Using copy functions 2
3
Touch the button for the desired settings, and then touch [Position
Setting].
4
Select the desired position.
– Touch [Auto] to automatically determine the stapling or hole-punching
position according to the orientation of the loaded original. The paper is
stapled or holes are punched along the long side of the paper if the
original length is 11-11/16 inch (297 mm) or less or along the short side
of the paper if the original length is more than 11-11/16 inch (297 mm).
When the "2 Position" Staple setting is selected
5
Touch [OK], and then touch [OK] in the next two screens that appear.
Otherwise, touch [Main Screen].
The Basic screen appears again.
2
Note
The number of punched holes differs depending on the country (region) where the
unit is installed. For details, consult your service representative.