Konica Minolta bizhub 501 User Manual
Page 147
501/421/361
1-134
Setup items by operation
1
EAP-TTLS In-
ternal Authenti-
cation
User ID
Enter an anonymous name to be used for authentica-
tion of EAP-TTLS (up to 128 alphanumeric characters).
When EAP-Type is [EAP-TTLS] or [Depend on Server],
a setting can be made.
Protocol
Select the internal authentication protocol of EAP-
TTLS. When EAP-Type is [EAP-TTLS] or [Depend on
Server], a setting can be made.
Encryption Strength
Select the encryption strength when a cypher commu-
nication is made in TLS.
•
Low : Communication is made in all key lengths.
•
Mid : Communication is made in key lengths ex-
ceeding 56 bits.
•
High : Communication is made in key lengths ex-
ceeding 128 bits.
When [OFF] or other than [EAP-MD5] is selected for
EAP-Type, a setting can be made.
Verify Server
Certification
Validity Pe-
riod
A selection is made to see if the server certificate is val-
id or not.
CA Reliabili-
ty
A selection is made to see if there is nothing abnormal
with the chain (certification pass) of the server certifi-
cate. A checking of the chain is made by reference to
the route CA certificate registered on this machine. For
details, refer to
"Installation of CA Certificate" on
Server ID
A selection is made to decide whether or not the com-
mon name (CN) of the server certificate coincides with
the address of the server.
When the CN is checked, make a setting of [Server ID].
Server ID
Enter the server ID (up to 64 alphanumeric characters).
This setting is required when the CN of the server cer-
tificate is checked.
Is the CN of the server
certificate checked ?
CA Certificates
An indication is made to see if the route CA certificate
is installed.
When the CA reliability of the server certificate is
checked, this is required to be installed.
For details of the method for installation, refer to
stallation of CA Certificate" on page 1-132
.
Is the CA reliability of
the server certificate
checked?
Client Certificates
Use the client certificate of this machine to make a se-
lection to decide whether or not the authentication in-
formation is encrypted. When the client certificate is
installed in this machine, a setting can be made.
When [EAP-TLS] is selected for EAP-Type, the client
certificate is indispensable.
When EAP-Type is [EAP-TTLS] or [PEAP], a setting can
also be made.
Network Stop Time
When authentication is not completed successfully
within a specified period of time after the start of au-
thentication, all the network communications are
stopped.
When a respite time is set from the start of authentica-
tion until the stop of the network communication, make
a check in.
Stop Time
Set a respite time (in seconds) from the start of authen-
tication until the stop of the network communication.
If you want to make authentication again after the stop
of the network communication, turn on the main power
of this machine again after turning it off.
Item
Definition
Prior confirmation