Konica Minolta bizhub C3350 - Manual (Page 39)

1.5 Available operations in Administrator mode 1
[Applied Functions] 1-33
5
From [Protocol Setting] on the [IPsec Settings] screen, click [Edit] and specify the protocol used for IP-
sec communication.
% In [Protocol Setting], up to 10 items can be registered.
6
Click [Apply], and close the [IPsec Settings] screen.
7
In the Administrator mode, select [Security] - [IPsec] - [IPsec] - [General Settings], then configure the
following settings.
8
From [IPsec Policy] on [IPsec] screen, click [Edit], then configure the following settings.
[Key-ID String] Enter the Key-ID to be specified for the Pre-Shared Key (using ASCII charac-
ters of up to 128 bytes).
Item Description
[Name] Enter the protocol name (using up to 10 characters).
[Protocol Identification
Setting] Select a protocol used for IPsec communication.
[Port No.] If [TCP] or [UDP] has been selected in [Protocol Identification Setting], specify
the port number used for IPsec communication.
Item Description
[IPsec] Select whether or not to enable IPsec.
[Disable] is specified by default.
[Dead Peer Detection] If no response can be confirmed from the peer in a certain period, the SA with
the peer is deleted.
Select a time that elapses before sending survival confirmation information to
the peer how has not responded.
[60] is specified by default.
[Cookies] Select whether or not to enable the defense using Cookies against denial-of-
service attacks.
[Disable] is specified by default.
[ICMP Pass] Select whether or not to apply IPsec to the Internet Control Message Protocol
(ICMP).
Select [Enable] to allow the ICMP packets to pass without applying IPsec to
the ICMP.
[Enable] is specified by default.
[ICMPv6 Pass] Select whether or not to apply IPsec to the Internet Control Message Protocol
for IPv6 (ICMPv6).
Select [Enable] to allow the ICMPv6 packets to pass without applying IPsec to
the ICMPv6.
[Enable] is specified by default.
[Default Action] Select an action to be taken if no settings meet the [IPsec Policy] while IPsec
communication is enabled.
Select [Deny] to discard IP packets that do not meet the [IPsec Policy] settings.
[Allow] is specified by default.
Item Description
[Name] Enter a name for the IPsec policy (using up to 10 characters).
[Peer] Select a peer setting.
Select the setting from those registered in [Peer] on the [IPsec Settings]
screen.
[Protocol Setting] Select an appropriate protocol.
Select the setting from those registered in [Protocol Setting] on the [IPsec Set-
tings] screen.
[SA] Select a peer setting.
Select the setting from those registered in [SA] on the [IPsec Settings] screen.
Item Description