Konica Minolta bizhub C3350 - Manual (Page 90)

[Applied Functions] 2-22
2.8 Searching for a destination using the LDAP server 2
Using SSL communication
Communication between this machine and the LDAP server is encrypted with SSL.
Configure the setting if your environment requires SSL encryption communication with the LDAP server. To
make SSL communications, enable SSL.
In the administrator mode, select [Network] - [LDAP Settings] - [LDAP Server Registration], then configure the
following settings.
[Server Address] Enter the LDAP server address.
Use one of the following formats.
•
Example of host name entry: "host.example.com"
• Example of IP address (IPv4) entry: "192.168.1.1"
• Example of IP address (IPv6) entry: "fe80::220:6bff:fe10:2f16"
[Port Number] If necessary, change the LDAP server port number.
Normally, you can use the original port number.
[389] is specified by default.
[Search Base] Specify the starting point to search for a user to be authenticated (using ASCII
characters of up to 255 bytes).
The range from the entered origin point, including the following tree structure,
is searched.
Example of entry: "cn=users,dc=example,dc=com"
[Timeout] If necessary, change the time-out time to limit a communication with the LDAP
server.
[60] sec. is specified by default.
[Max. Search Re-
sult] Change the maximum number of destinations to be displayed as search re-
sults, if necessary.
[100] is specified by default.
[Authentication
Method] Select the authentication method to log in to the LDAP server.
Select one appropriate for the authentication method used for your LDAP serv-
er.
[anonymous] is specified by default.
[Login Name] Log in to the LDAP server, and enter the login name to search for a destination
(using up to 255 bytes).
[Password] Enter the password (using up to 128 bytes).
To enter (change) the password, select the [Change Password] check box,
then enter a new password.
[Domain Name] Enter the domain name to log in to the LDAP server (using ASCII characters of
up to 64 bytes).
If [GSS-SPNEGO] is selected in [Authentication Method], enter the domain
name of Active Directory.
[Select Server Au-
thentication Meth-
od] Select the LDAP server authentication method.
•
[Set Value]: Use the settings of [Login Name], [Password], and [Domain
Name].
• [Dynamic Authentication]: The system prompts you to enter the user name
and password when Address Search (LDAP) is carried out.
[Set Value] is specified by default.
[Use Referral] Select whether or not to use the referral function, if necessary.
Make an appropriate choice to fit the LDAP server environment.
[On] is specified by default.
[Search Condition
Attributes] Select attributes to be specified when the LDAP search is carried out. The set-
ting can be switched between [Name] (cn) and [Nickname] (displayName).
[Name] is specified by default.
[Initial Setting for
Search Details] Specify LDAP search conditions.
[OR] is specified by default in every case.
Item Description
Settings Description
[SSL/TLS] Select [Enable] to use SSL communication.
[Disable] is specified by default.