Konica Minolta Printgroove User Manual
Page 32
Using the Printgroove POD Driver
3
Printgroove POD Driver
3-9
–
The screen expands and the [Options] and [Module Config] settings
are displayed.
–
All available Printgroove POD modules are listed in the [Options]
field.
2
If a module is available in your print shop, select the corresponding [Se-
lect Available Module] checkbox. All selected modules appear in the
[Available Drivers] drop-down menu.
–
Note: If you select a module that is not available then later send a
print job to that unsupported module, you will receive an error.
3
To specify which of the selected modules will appear as the default se-
lection, select the [Set As Default] radio button that corresponds to the
module.
4
When the [Options] settings are completed, click the [OK] button to
save your settings.