Konica Minolta Printgroove - Manual (Page 24)

Using the Printgroove POD Driver 3
Printgroove POD Driver 3-1
3 Using the Printgroove POD Driver
Both Printgroove POD Serve and Guide will accept native files. However,
only PDF files may be submitted to Printgroove POD Queue for printing.
Once the Printgroove POD Driver is installed, you may use it to transfer PDF
files to the selected Printgroove POD module. If your print job is not a PDF
file, you may also use the driver to convert native files to PDF. You may con-
vert a single file. You may convert several files, combine them into one PDF
file and then transfer that document to the selected POD module.
The steps for initiating this transfer are the same regardless of the destination
POD module. Once you select a POD module, however, the process for
completing the transfer is module-specific.
Section 3.1 - Transferring a Native Document is a comprehensive tutorial that
explains how to transfer (and convert to PDF, if required) files to all of the
POD modules. You do not need to read the entire section, only the steps re-
lated to the Printgroove POD module to which you wish to send your print
job.
To locate the exact information you need, follow this guideline:
First
-
Complete Steps 1 through 10 regardless of your selected destination
POD module
Next
-
If Printgroove POD Serve is your destination module, complete Steps
11 through 13
- If Printgroove POD Queue is your destination module, complete Steps
14 through 17