Konica Minolta bizhub 20 - Manual (Page 61)

Chapter 7
52
Using a non-KONICA
MINOLTA cordless external
handset
7
If your non-KONICA MINOLTA cordless
telephone is connected to the telephone line
cord (see page 51) and you typically carry the
cordless handset elsewhere, it is easier to
answer calls during the Ring Delay.
If you let the machine answer first, you will
have to go to the machine so you can press
Tel/R to transfer the call to the cordless
handset.
Using Remote Codes
7
Remote Activation Code
7
If you answer a fax call on an extension or
external telephone, you can tell your machine
to receive it by pressing the Remote
Activation Code l51. Wait for the chirping
sounds then replace the handset. (See Fax
Detect on page 44.) Your caller will have to
press start to send the fax.
If you answer a fax call at the external
telephone, you can make the machine
receive the fax by pressing Start.
Remote Deactivation Code
7
If you receive a voice call and the machine is
in F/T mode, it will start to sound the F/T
(double-ring) after the initial ring delay. If you
pick up the call on an extension telephone
you can turn the F/T ring off by pressing #51
(make sure you press this between the rings).
If the machine answers a voice call and
pseudo/double-rings for you to take over, you
can take the call at the external telephone by
pressing Tel/R.
Turning on the Remote Codes
7
You need to turn the Remote Codes setting to
on to use the Fax Receive Code and
Telephone Answer Code.
a
Make sure you are in Fax mode.
b
Press Menu 2, 1, 4.
Press OK.
c
Press a or b to choose On.
d
If you do not want to change the Fax
Receive Code, press OK.
e
If you do not want to change the
Telephone Answer Code, press OK.
f
Press Stop/Exit.
Changing the Remote Codes
7
The preset Remote Activation Code is l51.
The preset Remote Deactivation Code is #51.
If you are always disconnected when
accessing your External TAD, try changing
the three-digit remote codes, for example ###
and 555.
a
Make sure you are in Fax mode.
b
Press Menu 2, 1, 4.
c
Press a or b to choose On or Off.
Press OK.
d
If you chose On in step c, enter the new
Remote Activation Code.
Press OK.
e
Enter the new Remote Deactivation
Code.
Press OK.
f
Press Stop/Exit.