Konica Minolta bizhub 601 - Manual (Page 38)

751/601 1-25
Setup items by operation 1
1.9 Sending scan data by E-mail
Specify settings for sending scan data by E-mail.
Scan data can be sent to a specified E-mail address as an attached file of the message.
If the SMTP server supports SMTP over SSL or Start TLS, setting is recommended. Because communication
can be encrypted by SSL/TLS, the machine can communicate securely with the server.
If the SMTP server requires SMTP authentication, the SMTP authentication setting must be specified.
If the SMTP server requires POP before SMTP authentication, the POP before SMTP authentication setting
must be specified. In addition, if the POP server supports POP over SSL or APOP authentication, settings for
these can be specified.
Specify the settings according to the following flowchart.
2
Note
For details on registering E-mail addresses, refer to "Registering or editing an address book
destination" on page 1-168 .
For details on the E-mail-based file transmission, refer to the User’s Guide [Network Scan/Fax/Network
Fax Operations].
1.9.1 TCP/IP Settings
Specify settings to use this machine in a TCP/IP network environment.
For details, refer to "Specifying general settings for TCP/IP-based communication" on page 1-2 .
TCP/IP Settings
E-mail TX (SMTP)
Communicate with the SMTP
server using SSL/TLS?
SMTP Authentication? POP before SMTP?
Yes No Yes No Yes No
SMTP over SSL/Start TLS SMTP Authentication POP before SMTP
➀ POP over SSL?
➁ APOP?
Yes No
➀ POP over SSL
➁ APOP Authentication
Finish