Konica Minolta bizhub 750 - Manual (Page 200)

Application Software 4
750/600 4-37
Application Software
Chapter 4
7
Type the 8-digit Administrator Password registered in the machine in
the “Administrator Password” box.
8
Click the [Next].
? What happens if a wrong Administrator Password is entered?
% If a wrong Administrator Password is entered, a message appears
saying that there is a mismatch in the passwords and entry of the
Administrator Password will be prohibited for five sec. Wait for
some while before entering the correct Administrator Password.
% If the Enhanced Security mode is set to [ON], entry of a wrong pass-
word is counted as unauthorized access. If a wrong Administrator
Password is entered a predetermined number of times (once to
three times) set by the Administrator of the machine or more, a
message appears saying that the machine accepts no more Admin-
istrator Passwords because of unauthorized access for any subse-
quent entry of the Administrator Password. The machine is then set
into an access lock state. To cancel the access lock state, turn off,
and then turn on, the main power switch of the machine. When the
main power switch is turned off, then on again, wait at least 10 sec-
onds to turn it on after turning it off. If there is no wait period be-
tween turning the main power switch off, then on again, the
machine may not function properly.
Here is the sequence, through which the main power switch and
sub power switch are turned on and off:
Turn off the sub power switch
→ Turn off the main power switch →
Turn on the main power switch → Turn on the sub power switch
% The Management Data Encryption Key and Image Data Encryption
Key are subject to Restore. Make sure that the settings when Back-
up is executed are not forgotten, since settings are restored to
those set during Backup after Restore.
600_security_E.book 37 ページ ２００６年１２月２７日 水曜日 午前７時５０分