Konica Minolta bizhub 750 - Manual (Page 83)

2 Administrator Operations
2-64 750/600
Ad
minist
ra
to
r Op
er
at
ions
Chapter 2
2.10.4 Setting the Management Data Encryption Key
Through the steps given below, you set encryption of management data
stored in the flash memory and HDD.
2
Note
When the main power switch is turned off, then on again, wait at least 10
seconds to turn it on after turning it off. if there is no wait period between
turning the main power switch off, then on again, the machine may not
function properly.
Here is the sequence, through which the main power switch and sub
power switch are turned on and off:
Turn off the sub power switch
→ Turn off the main power switch → Turn
on the main power switch → Turn on the sub power switch
Do not leave the machine with the Administrator Setting mode setting
screen left shown on the display. If it is absolutely necessary to leave the
machine, be sure first to log off from the Administrator Setting mode.
<Setting can be made only from the control panel>
0 For the procedure to call the HDD Setting menu to the display, see steps
1 and 2 of “Setting the HDD Lock Password” on page 2-52.
1
Call the HDD Setting to the screen from the control panel.
2
Touch [HDD Encryption Setting].
600_security_E.book 64 ページ ２００６年１２月２７日 水曜日 午前７時５０分