Konica Minolta FK-502 - Manual (Page 326)

Utility Mode 11
bizhub 360 11-59
Utility Mode
Ch
ap
te
r 11
11.14 Report Settings
You may select the Report Settings to be On or Off. This settings prints the
reports of communication management, communication result and reserva-
tion. If ON is selected, the manner of printing may also be selected.
*
indicates factory default setting.
!
Detail
While in the selection of [1 Dest. at time], the output of the Broadcast
Result Report is restricted only when a redial is tried with no successful
transmission available. When a transmission is terminated normally, no
report is issued.
When selecting [ON] in "TX Result Report Check", the TX Report will be
printed if YES is selected. The report will not be printed if NO is selected.
Item Description Available value
Activity Report Determines whether to print the report and
the timing at which the report will be printed
out. OFF / Daily / Every 100
Comm.
*
/ 100/Daily
When you set the output
of Activity Report to [Dai-
ly] or [100/Daily], you can
also set the time to out-
put the report.
TX Report ON / If TX Fails
*
/ OFF
Sequential TX
Report ON
*
/ OFF
Timer Reserva-
tion TX Report ON
*
/ OFF
Confidential RX
Report ON
*
/ OFF
Bulletin TX Re-
port ON
*
/ OFF
Relay TX Result
Report ON
*
/ OFF
Relay Request
RX Report ON
*
/ OFF
PC-Fax TX Er-
ror Report ON / OFF
*
Broadcast Re-
sult Report Set up the Broadcast Result Report printing
method. All Dest.
*
/ 1 Dest. at a
time
TX Result Re-
port Check Determines whether to display the trans-
mission result report select screen. If you
select [ON], it will be displayed after each
transmission. OFF
*
/ ON