Konica Minolta Digital StoreFront User Manual
Page 86
Digital StoreFront 5.2 Administration Reference
86
The Fiery JDF Configurator dialog will open. At this point, Remote Print Center (RPC) is
installed on your computer and there is no need to configure Fiery JDF at this time. (You can
configure Digital StoreFront integration with Fiery JDF later if needed following the steps in the
Digital StoreFront - Fiery Integration Administrator Guide.)
15.
Click Cancel.
16.
Click Yes to confirm the cancellation.
The Fiery JDF Configurator setup will close and EFI Remote Print Center Setup Wizard will
report that the RPC installation was successful.
17.
Click Finish.
18.
You will be prompted to restart your computer to complete the configuration process.
See Also
●
Remote Print Center Install and Uninstall
●
To remove an RPC from the local RPC computer
●
Manage Remote Print Center
●
Monitor Remote Print Center Activity
●
Output Device Support
●
Output Devices
●
Print Shop Management
●
Output Device Support
●
Output Devices
●
Print Shop Management