AEG BE3003021W - Manual (Page 37)

The pyrolytic cleaning
procedure cannot start:
• if you did not remove the core
temperature sensor plug from the
socket.
• if you did not fully close the oven
door.
Remove the worst dirt manually.
CAUTION!
If there are other appliances
installed in the same cabinet,
do not use them at the same
time as the function: Pyrolysis.
It can cause damage to the
appliance.
1. Clean the inner side of the door with
hot water, so that the residues do not
burn from the hot air.
2. Activate the appliance and select
from the main menu the function:
Pyrolysis. Press
to confirm.
3. Set the duration of the cleaning
procedure:
Option Description
Quick 1 h for a low
degree of dirt
Normal 1 h 30 min for
a usual de-
gree of dirt
Intense 2 h 30 min for
a high degree
of dirt
4. Touch to confirm.
When the pyrolytic cleaning
starts, the appliance door is
locked.
WARNING!
After the function is
completed, the appliance is
very hot. Let it cool down.
There is a risk of burns.
After the function is
completed, the door stays
locked for the cool down
phase. Some of the appliance
functions are not available
during the cool down phase.
12.4 Removing and installing
the door
You can remove the door and the
internal glass panels to clean it. The
number of glass panels is different for
different models.
WARNING!
Be careful when you remove
the door from the appliance.
The door is heavy.
1. Open the door fully.
2. Fully press the clamping levers (A) on
the two door hinges.
A
A
3. Close the oven door to the first
opening position (approximately 70°
angle).
4. Hold the door with one hand on each
side and pull it away from the
appliance at an upwards angle.
5. Put the door with the outer side
down on a soft cloth on a stable
surface. This is to prevent scratches.
6. Hold the door trim (B) on the top
edge of the door at the two sides
and push inwards to release the clip
seal.
1
2
B
ENGLISH 37