AEG BE3003021W - Manual (Page 39)

Problem Possible cause Remedy
The oven does not heat up. The clock is not set. Set the clock.
The oven does not heat up. The necessary settings are
not set. Make sure that the settings
are correct.
The oven does not heat up. The automatic switch-off is
activated. Refer to "Automatic switch-
off".
The oven does not heat up. The Child Lock is on. Refer to "Using the Child
Lock".
The oven does not heat up. The door is not closed cor-
rectly. Fully close the door.
The oven does not heat up. The fuse is released. Make sure that the fuse is
the cause of the malfunction.
If the fuse releases again
and again, contact a quali-
fied electrician.
The lamp does not operate. The lamp is defective. Replace the lamp.
The display shows F111. The plug of the core tem-
perature sensor is not cor-
rectly installed into the sock-
et. Put the plug of the core tem-
perature sensor as far as
possible into the socket.
The display shows an error
code that is not in this table. There is an electrical fault. • Deactivate the oven with
the house fuse or the
safety switch in the fuse
box and activate it again.
• If the display shows the
error code again, contact
the Customer Care De-
partment.
Steam and condensation
settle on the food and in the
cavity of the oven. You left the dish in the oven
for too long. Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.
13.2 Service data
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre.
The necessary data for the service centre
is on the rating plate. The rating plate is
on the front frame of the appliance
cavity. Do not remove the rating plate
from the appliance cavity.
We recommend that you write the data here:
Model (MOD.) .........................................
ENGLISH 39