AEG DE4003000M - Manual (Page 26)

11. WHAT TO DO IF…
WARNING!
Refer to the Safety chapters.
Problem Possible cause Solution
The oven does not heat
up The appliance is switch-
ed off Switch on the appliance
The oven does not heat
up The clock is not set Set the clock. Refer to
"Setting the clock"
The oven does not heat
up The necessary settings
are not set Make sure, the settings
are correct
The oven does not heat
up The automatic cut-out is
switched on Refer to "Automatic cut-
out"
The oven does not heat
up The fuse is released Make sure, if the fuse is
the cause for the mal-
function. If the fuse re-
leases again and again,
refer to an authorized
electrician
The oven lamp does not
operate The oven lamp is defec-
tive Replace the oven lamp
The display shows an er-
ror code that is not in
this list There is an electronic
fault • Switch off the appli-
ance with the house
fuse or the safety
switch in the fuse box
and switch it on again
• If the display shows
the error code again,
refer to the Customer
Care Department
If you cannot find a solution to the prob-
lem yourself, contact your dealer or the
service centre.
The necessary data for the service centre
is on the rating plate. The rating plate is on the front frame of the appliance cavi-
ty.
We recommend that you write the data here:
Model (MOD.) .........................................
Product number (PNC) .........................................
Serial number (S.N.) .........................................
12. INSTALLATION
WARNING!
Refer to the Safety chapters. The built-in unit must meet the
stability requirements of DIN
68930.
26 www.aeg.com