Olympus C-4040 Zoom - Manual (Page 183)

183
Troubleshooting
Chapter 12
1 The power is off.
2 The batteries are
loaded incorrectly.
3 The batteries are
exhausted.
4 The batteries are
temporarily unable to
function.
5 It is connected to a
personal computer.
6 The camera is in the
sleep mode.
1 Set the mode dial to any
position except OFF to turn
on the camera.
2 Reload the batteries
correctly.
3 Replace the batteries with
new ones.
4 The batteries may be too
cold. Keep them warm while
using the camera.
5 The camera will not operate
while it is connected to a
personal computer.
6 Operate the camera (press
the shutter button, turn the
mode dial, etc.)
P. 30
P. 25
P. 25
P. 27
P. 162
P. 30
POSSIBLE CAUSES CORRECTIVE ACTION REF. PAGE
The camera does not work.
No picture is taken when the shutter button is pressed.
1 The mode dial is set to
.
2 Focus and exposure
are not locked.
3 The memory gauge is
full.
4 The flash has not
finished charging.
1 Set the mode dial to any
position except .
2 Release your finger from the
shutter button and try
focusing again. When the
green lamp stops blinking,
focusing is successful.
3 Wait until there is room in
the memory gauge.
4 Release your finger from the
shutter button. When the
orange lamp stops blinking,
shoot again.
P. 59
P. 67
P. 76
P. 84