Olympus C-4040 Zoom - Manual (Page 186)

186
Troubleshooting (Cont.)
Chapter 12
POSSIBLE CAUSES CORRECTIVE ACTION REF. PAGE
Picture rotate, Picture protect, Single-frame erase, All-frame erase,
Print reserve and Card formatting cannot be performed.
1 A write-protect
adhesive seal is affixed
to the card.
1 Use the card after peeling
off the seal. Do not reuse
the write protect seal.
P. 28
When the camera is connected to a computer, an error message
appears while data is being transferred to the computer.
1 The cable is not
plugged in correctly.
2 The power is off.
3 The batteries are
exhausted.
4 The USB driver is not
installed properly.
1 Connect the cable correctly.
2 Set the mode dial to .
3 Replace the batteries with
new ones or use the
optional AC adapter.
4 Try installing the USB driver
again. Confirm that the
computer recognizes the
camera.
P. 162
P. 163
P. 25, 175
P. 162–
165
1 The flash is in the auto-
flash mode.
1 This “red-eye phenomenon”
occurs with all cameras when a
flash is used. It is caused by
light from the flash reflecting off
the retina at the back of the
eye. Red-eye varies depending
on the individual and the
shooting conditions such as
ambient lighting. Use of the
Red-Eye Reducing Pre-Flash
mode significantly reduces this
phenomenon.
P. 81
The subject’s eyes appear red in pictures recorded with the flash.