Olympus C-4040 Zoom - Manual (Page 185)

185
Troubleshooting (Cont.)
Chapter 12
POSSIBLE CAUSES CORRECTIVE ACTION REF. PAGE
The flash does not fire.
1 The flash is set to the
off mode.
2 The subject is lighted.
3 Sequential shooting is
on.
4 You are recording
movies.
5 Panorama shooting is
performed.
6 FUNCTION is set to
BLACK/WHITE BOARD.
1 Press the button to select
a flash mode other than .
2 Set the flash to Fill-In mode.
3 Set DRIVE to
in the
menus.
4 Set the mode dial to any
position other than .
5 Set PANORAMA to OFF in
the menus.
6 Set FUNCTION to OFF in
the menus.
P. 81–83
P. 81
P. 88
P. 59
P. 98
P. 97
Pictures you have already taken do not appear on the monitor.
1 The camera is in the
shooting mode.
2 There is no picture in
the card.
3 There is a problem with
the card.
4 The camera is
connected to a TV.
1 Set the mode dial to .
2 NO PICTURE appears on the
monitor. Record pictures.
3 See the error code chart.
4 The monitor does not
function when the camera is
connected to a TV.
P. 116
P. 37, 38,
191
P. 190
P. 133
1 The diopter is not
adjusted properly.
1 Adjust the diopter again. P. 35
1 The brightness is not
adjusted properly.
2 The monitor is exposed
to direct sunlight.
1 Adjust the brightness.
2 Block the sunlight.
P. 76
The monitor is not clear.
The viewfinder display is not clear.