Install the olympus master software, P. 36, P. 36) – Olympus FE-300 User Manual
Page 36: Usi ng olympus mast er
36
EN
Usi
ng OLYMPUS Mast
er
Before installing the OLYMPUS Master software, please confirm that your computer is compatible with the
following system requirements.
For newer operating systems, please refer to the Olympus web site as shown on the back cover of this
manual.
Operating environment
Windows
OS
Windows 2000 Professional/XP Home Edition/XP Professional/Vista
CPU
Pentium III 500 MHz or later
RAM
256 MB or more
Hard disk capacity
500 MB or more
Monitor
1,024 × 768 pixels or more
65,536 colors or more (16.77 million colors or more recommended)
Other
USB port or IEEE 1394 port
Internet Explorer 6 or later
QuickTime 7 or later recommended
DirectX 9 or later recommended
Note
• Windows 98/98SE/Me are not supported.
• Use a computer with a pre-installed operating system. Operations are not guaranteed on
home-built computers or computers with an updated operating system.
• Operations are not guaranteed when using an added USB port or IEEE 1394 port.
• To install the software, you must log on as a user with administrators’ privileges.
Macintosh
OS
Mac OS X v10.3 or later
CPU
Power PC G3 500 MHz or later
Intel Core Solo/Duo 1.5 GHz or later
RAM
256 MB or more
Hard disk capacity
500 MB or more
Monitor
1,024 × 768 pixels or more
32,000 colors or more (16.77 million colors or more recommended)
Other
USB port or IEEE 1394 port (FireWire)
Safari 1.0 or later (1.3 or later recommended)
QuickTime 6 or later
Note
• Mac versions earlier than OS X 10.3 are not supported.
• Operations are not guaranteed when using an added USB or IEEE 1394 (FireWire) port.
• To install the software, you must log on as a user with administrators’ privileges.
• Be sure to remove the media (drag & drop onto the trash icon) before performing the following
operations. Failure to do so could result in unstable computer operation and the need to
reboot.
• Disconnect the cable connecting the camera to the computer
• Turn off the camera
• Open the camera’s battery/card compartment cover
Install the OLYMPUS Master software