Getting to know your camera better, Shooting tips and information, Tips before you start taking pictures – Olympus FE-300 User Manual

Page 42: The card cannot be used, P. 42, A b c d

Advertising
background image

42

EN

Get

ti

ng t

o

k

now

y

our camera bet

ter

Getting to know your camera better

The battery is not charged

• Charge the battery with the charger.

The battery is temporarily unable to function because of the cold

• Battery performance declines in low temperatures, and the charge may not be sufficient to turn on

the camera. Remove the battery and warm it by putting it in your pocket for a while.

If the contact area of the card is dirty/dust, data in the card cannot be read and the [CARD SETUP]
screen appears. In this case, select [xD CARD CLEAN], press

, remove the card, and then wipe

the contact area with a soft dry cloth.

The camera is in sleep mode

• To save battery power, the camera automatically goes into sleep mode and the monitor turns off if

there is no operation for 3 minutes when the camera is turned on. No picture is taken even if the
shutter button is fully pressed in this mode. Operate the zoom lever or other buttons to restore the
camera from sleep mode before taking a picture. If the camera is left on for 12 minutes, it
automatically turns off. Press o to turn the camera on.

The mode dial is in the position of

R

• No pictures can be taken when the shooting guide is being displayed. Take pictures after selecting

the settings by following the shooting guide, or turn the mode dial and set it to a shooting mode other
than

R.

The flash is charging

• Wait until the

# (flash charge) mark stops blinking before taking the picture.

The camera's internal temperature increases

• With prolonged camera use, the internal temperature may increase, resulting in automatic

shutdown. If this occurs, remove the battery from the camera and wait until the camera has
sufficiently cooled. The camera’s external temperature may also increase during use, however this
is normal and does not indicate malfunction.

The memory gauge is full

• No pictures can be taken when the memory gauge is full. Wait until there is space in the memory

gauge.

Shooting tips and information

Tips before you start taking pictures

The camera does not turn on even when a battery is loaded

The card cannot be used

No picture is taken when the shutter button is pressed

a b c d

Before taking

any pictures

(Off)

Maximum reached

(All lit)

After taking

one picture

(Lit)

After taking

several pictures

(Lit)

Shoot

Shoot

Shoot

Wait

Advertising