Brother FAX-921 - Manual (Page 85)

IV - 45
1.16 Handset Mount,* Hook Switch PCB,* and Dummy Mount**
(*For models except the FAX-910, **For the FAX-910 only)
(1) Insert the tip of a flat screwdriver into the slits of the handset mount* (or the dummy mount**)
and unhook the mount from the main frame.
(2) To replace the hook switch PCB*, you need to disconnect the hook switch harness from the
main PCB. (Refer to Section 1.10.)
n n Reassembling Notes
• When reinstalling the handset mount* (or the dummy mount**), first align the left edge with the
main frame and then push down the right edge.