Pioneer AVIC-HD1BT - Manual (Page 81)

79
NA
V
I
Ch
ap
te
r
9
Mod
ify
in
g
th
e G
ene
ra
l Se
tt
in
g
s f
o
r N
av
ig
at
io
n
F
u
nc
ti
on
s
AZERTY:
Changing the unit between km
and miles
This setting controls the unit of distance and
speed displayed on your navigation system.
1
Touch [Settings] in the navigation menu,
then touch [Regional Settings].
2
Touch [km / mile] to change the setting.
Each time you touch the key changes that set-
ting.
km (default):
Show distance in kilometres.
mile:
Show distance in miles.
Mile&Yard:
Show distance in miles and yards.
Changing the virtual speed of
vehicle
When calculating expected time of arrival and the
number of hours to the destination, set the aver-
age speed for the motorway or ordinary roads
using [+] and [–].
1
Touch [Settings] in the navigation menu,
then touch [Regional Settings].
2
Touch [Average Speed].
3
Touch [+] or [–] to set their speed.
❒ The estimated time of arrival is not neces-
sarily estimated based on this speed value.
Checking the Setting Related
with Hardware
The hardware status, including the driving status
of a vehicle, positioning status by satellite, learn-
ing status of the 3D sensor, and cable connection
status etc., can be checked.
Checking the connections of
leads and installation positions
Check that leads are properly connected between
the navigation system and the vehicle. Please
also check whether they are connected in the
correct positions.
1
Touch [Settings] in the navigation menu,
then touch [Hardware].
2
Touch [Connection Status].
The Connection Status screen appears.
(1) Speed Pulse
The Speed Pulse value detected by the naviga-
tion system is shown. [0] is shown while the
vehicle is stationary.
(2) GPS Antenna
Indicates the connection status of the GPS
aerial, the reception sensitivity, and from how
many satellites the signal is received. If the
signal is received correctly, [OK] is displayed.
If reception is poor, [NOK] appears. In such
case, please change the installation position
of the GPS aerial.
(3) Phone Connection Status
Indicates the connection status of the Blue-
tooth unit and the signal strength of link-up
between the Bluetooth unit and the mobile
phone. If the connection of Bluetooth unit is
correctly, [OK] is displayed. [NOK] appears
when the Bluetooth unit is not connected or
incorrectly connected.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
MAN-HD1BT-SOFTW-EN.book Page 79 Thursday, April 20, 2006 3:47 PM