Mechanical problems – Brother PERSONAL EMBROIDERY SYSTEM PE-150 User Manual
Page 67
Symptom
1. Machine operation is slow and
noisy
2. The machine does not start
3. The needle breaks
64
Mechanical problems
Probable cause
1. Thread scraps and dust have
accumulated under the needle plate.
1. The “START/STOP” button is not
pressed.
2. The main power switch is in the off
position.
3. The presser foot is not lowered.
4. Check Error messages.
1. The needle is not correctly inserted.
2. The correct needle is not used.
Remedy
1. Remove the thread scraps and dust
with a brush.
1. Press the “START/STOP” button.
2. Turn the power on.
3. Lower the presser foot.
4. See “ERROR MESSAGE” on page 59.
1. Remove the needle and reset a new
needle properly.
2. Change to the proper needle.
Caution
●
This machine is equipped with a thread breakage sensor. Accordingly, if the upper thread is
not threaded, the machine will not operate even if the “START/STOP” button is pressed.
In addition, a loud noise which is different from the normal operation noise is generated by the
needle bar holding mechanism during layout changes, layout change tests and also when the
embroidery frame travels a lot during embroidery. This sound is normal and is not the result of
a malfunction.
●
If the power goes off during embroidering:
●
Turn the power off and unplug the machine. Damage may occur if the machine is on when
the power comes back on.
●
To start again, while the main power switch is off, plug the unit in. Then turn the main power
switch on and select an operation. Refer to page 54, using the “HELP” function to get back
to the point where the machine went off.