Pioneer AVG-VDP1 - Manual (Page 7)

Displaying the V.D.P. image
You can display the V.D.P. (Vehicle Dynamics
Processor) image on the display.
% Press V.ADJ on the display unit to
switch the display to the V.D.P. image.
# If the CAUTION screen is displayed, be sure
to read though the caution. And then touch OK
to confirm it.
# You can select a language for the CAUTION
screen and keyboard. (Refer to Selecting language
on page 29.)
# To return to the video of sources, press V.ADJ
again.
# Depending on the display unit, this function is
operable with NAVI/AV or MENU button instead
of V.ADJ button.
When using this unit for the
first time
When using this unit for the first time or after
resetting it, the following modes may appear:
1 Operation setting mode
2 Area setting mode
3 Language setting mode
4 CAUTION screen
1 Touch Normal to use this unit normally.
Refer to Demonstration mode on this page.
# To turn the demonstration mode on, touch
Demo.
2 Select your area.
Refer to Selecting your area on page 29.
3 Select a desired language.
Refer to Selecting language on page 29.
4 Touch OKafter confirming the caution.
Sensor Learning.... appears on the display
and means that sensor initialization is not
complete. Until sensor initialization is finished
completely, all of the recording functions of
this unit cannot be used.
! The CAUTION screen is the important in-
formation for using this unit safely and
properly. Be sure to read through the cau-
tion before using this unit.
! Perform the RPM calibration before using
this unit. (Refer to Calibrating the RPMs on
page 28.)
Demonstration mode
If you do not perform an operation within
about five minutes, the animations start auto-
matically.
! Because demonstration mode is the func-
tion for displaying at stores, do not use this
function while driving.
% To turn demonstration mode off, turn
the ignition switch OFF and ON and then
touch Normal in operation setting mode.
Basic Operations
En
7
English
Section
03