Toshiba Qosmio G30 HD-DVD (PQG31) - Manual (Page 122)

7-2 User’s Manual
HW Setup
Display
This tab lets you customize your computer’s display settings for either the
internal LCD screen or for an external monitor.
Power On Display
Lets you select the display to be used when the computer is booted - this
setting is only available with standard VGA modes and cannot be
configured through the Windows Desktop properties.
TV Type
You can select the type of TV to receive the signal.
Auto-Selected Selects an external monitor if one is connected.
Otherwise, it selects the internal LCD (Default).
LCD + Analog RGB Selects both the internal LCD and external
monitor for simultaneous display.
If the connected external monitor does not support the selected SVGA
mode, selecting the LCD + Analog RGB mode will not display on that
monitor.
If the computer was using multiple display devices when it was last shut
down and those devices are still present when Windows starts again the
computer will continue to use the devices after Windows starts.
If the devices are no longer present the computer will use the display
specified in the BIOS “Power On Display” setting (if no external display
device is connected, the computer will use the internal (attached) LCD
display regardless of the BIOS “Power On Display” setting).
NTSC (JAPAN) For Japanese television sets (Default value).
PAL (S-Video) For European television sets.
525p (480p, D2) This can only be selected for models with
D-Video out port.
1125i (1080i, D3) This can only be selected for models with
D-Video out port.
750p (720p, D4) This can only be selected for models with
D-Video out port.
525i (480, D1) This can only be selected for models with
D-Video out port.
NTSC (US) For US television sets.
When the D video output terminal is connected to the television, select
either D1 through D4 in accordance to the terminal on the television.