Toshiba HDR5010 - Manual (Page 40)

Programming the Remote Control
The Digital TV recorder’s remote control can be programmed to operate certain TVs.
Follow the procedure below to programme the remote control.
1. Find the 3 digit code for your brand of TV from the brand codes, starting on page 46.
note:
• If your brand is not included in the list or the codes for your brand do not operate your TV, refer to the following
page for an automatic method of programming the remote control.
2. Press and hold the [ ] button and the [AD] button for 3 seconds, then the [ TV]
button flashes twice and lights ON.
3. Use the [0]-[9] buttons to enter the 3 digit code for your brand. The [ TV] button
flashes when each digit of the code is entered.
4. If a valid code has been entered, the [ TV] button will flash twice, slowly and then the
illumination goes off.
5. Check that the remote control operates your TV by pressing the [ TV] button. If not,
repeat the above procedure and try another code for your brand.
note:
• The codes you enter may be lost if weak batteries are not replaced immediately. Even if your TV brand is listed
in the code table, in some instances it may not be possible to operate all of the available functions.
TV standby
button
AD button
GUIDE
button
button
0-9 buttons
Additional Information
40
HDR5010 User Guide.indb 40 22/07/2010 10:38