Toshiba Magnia 3200 - Manual (Page 7)

Magnia Rack Conversion Kit
Version
7
Last Saved on 14/11/2001 11:48
Figure 1-52 Adjusting the bracket and securing two screws/washers
3. Secure the server to the “42” rack.
Using a Lift to Install the Server in a Rack
Install the server in a rack using a lift, by following the steps in Figures 1-
53 and 1-54.
1. Set the server on a lift. Extend one slide rail. Raise the lift so that the
screw holes on the bottom of the server are level with the holes in the
slide rail. Adjust the server’s position to align the screw holes.
Figure 1-53 Aligning the server’s position
TOSHIBA Europe GmbH 7
Magnia Rack Conversion Kit – 3030_3100_s00056-EN.doc – Gosen – Printed on 14/11/2001 as PRINTFILENAME