Toshiba Magnia Z300 - Manual (Page 40)

MegaRAID Configuration Console
About rebuild array
40
Using MegaRAID Configuration Console, you can rebuild array
by the following procedures.
1. Remove the fail drive. When remove the drive, operation of OS
may slow for a few minutes.
2. Click on “Scan Devices”. After clicking on, redrawing screen
may slow for a few minutes.
3. Insert new drive.
4. Click on “Scan Devices”.
5. Rebuild starts.
If rebuild doesn’t start, please click on “Scan Devices” again.
6. At “Device Progress”, you can check progress of rebuilding.
7. When Rebuild is completed, “Rebuild COMPLETED Success-
fully” records in “Log Data”.