Toshiba Satellite Pro S300L User Manual
Page 137
User’s Manual
7-3
S300L
LAN
Wake-up on LAN
This feature lets the computer’s power be turned on when it receives a
wake-up signal from the LAN.
Power will be automatically turned on when a signal is received from an
administrator’s computer which is connected via a network.
The following settings can be changed when the Built-in LAN is
Enabled
.
Connect the AC adaptor when using the Wake-up on LAN function. The
battery retention time will be shorter than the times listed in this manual
when this function is enabled. Refer to the section in chapter 6,
Built-in LAN
This feature enables or disables the Built-in LAN.
Device Config
Device Configuration
This option allows you to set how the computer’s hardware devices will be
configured.
Do not install or remove a memory module while Wake-up on LAN is
enabled.
■
The Wake-up on LAN function consumes power even when the system
is off. Leave the AC adaptor connected while using this feature.
■
To enable it, you must check both the “Allow the device to wake the
computer” and “Only allow management stations to wake the
computer” check box within the “Intel Network Connection”.
Enabled
Enables Wake-up on LAN (Default).
Disabled
Disables Wake-up on LAN.
Enabled
Enables Built-in LAN functions (Default).
Disabled
Disables Built-in LAN functions.
All Devices
The computer’s BIOS will setup and configure all
devices.
Setup by OS
The operating system will setup and configure all
of the devices that it can control (default).