Toshiba KV700 - Manual (Page 28)

English - 27 -
Programme Timers - Digital Only
This feature will set the television to go to a specifi c
channel at a certain time. It can be used to view
a particular programme, or by setting the mode
to daily or weekly, can be used to view a series of
programmes.
Press • MENU and Up or Down to select Timers item
menu and press OK to continue.
To add a timer, press the • YELLOW button on the
remote control. Then Add Timer window appears.
Channel : Left or Right keys will navigate the user
through the TV or Radio list.
Date : Starting date is entered via the Left/Right or
the numeric buttons.
Start : Starting time is entered via the Left/Right or
the numeric buttons.
End : Ending time is entered via the Left/Right or the
numeric buttons.
Change/Delete : permits or prohibits any modifi cations
for other users.
Duration: Duration between Start and End time.
Repeat: You can set a timer to be repeated as Once,
Daily or Weekly.
You can save the adjustments by pressing the •
GREEN key or cancel the process by pressing the
RED button.
You can edit the list via
• GREEN key and delete with
the RED button.
Sleep Timer - Analogue
The television can be set to turn itself Off after a
certain length of time.
When displaying analogue TV menu, use • Left or
Right button to select FEATURE menu.
Press
• Up or Down button to select Sleep Timer.
Use • Left or Right button to set the desired time.
The timer can be programmed between Off and 120
minutes in steps of 10 minutes.
If Sleep Timer is activated, at the end of the selected
time, the TV goes automatically to standby mode
Conditional Access
The Common Interface Slot, situated on the side of the
television, enables the insertion of a CAM (Conditional
Access Module) and card. These are purchased from
a service provider and allow additional subscription
broadcasts to be viewed. For more information, see
a service provider.
Insert the CAM and card into the Common Interface •
Slot, following the instructions provided with the
CAM.
Press the
• MENU button to display the main menu and
use the “ ” or “ ” button to highlight the Conditional
Access line and press the OK button:
Important:
Switch off the TV and unplug from the mains. •
The CAM should be correctly inserted, it is •
impossible to insert fully if reversed. The CAM or
the TV terminal may be damaged if the CAM is
forcefully inserted.
Connect the TV to the mains supply, switch on
•
and then wait for few moments until the card is
activated.
Some CAMs may require the following set up.
•
Please set the CAM by entering the IDTV menu,
Conditional Access then pressing the “OK” button.
(CAM set up menu is not displayed when it is not
required.)
To see the viewing contract information: enter IDTV;
•
press the “ MENU ” button, then highlight Conditional
Access and press the “ OK ” button.
When no module is inserted, “No Conditional
•
Access module detected” message appears on
the screen.
Refer to the module instruction manual for details
•
of the settings.
Note: Insert or remove the CI module only when the TV
is switched off or in standby mode.
Timers - Digital and Analogue, Conditional
Access
00_MB35_[GB]_3910UK_IDTV_NICKEL1_40740W_(IB_INTERNET)_10069649.indd 27 00_MB35_[GB]_3910UK_IDTV_NICKEL1_40740W_(IB_INTERNET)_10069649.indd 27 19.10.2010 08:34:06 19.10.2010 08:34:06